Alfa Overlock 8703 vs Janome AT 2000D
Technical comparison · Overlockers and sergers
Two four-thread overlockers with the same stated speed, 1300 stitches per minute, and the same longest stitch, 5 mm: on output the data does not separate them. Automation differs: the Janome has a needle threader, air-driven loopers and 2-thread conversion built in, while the Alfa's needle threader is manual.
| Parameter | ||
|---|---|---|
| Identity | ||
| Use tier | F2 — Intermediate | F3 — Advanced |
| Price | ||
| Price | 664 € | ~1000–2200 € |
| Universal specs | ||
| Dimensions (W×D×H) | — | 34.7 × 28.4 × 29.9 cm |
| Weight | — | 7.9 kg |
| Power | 120 W | — |
| Category specs | ||
| Maximum threads | 4 | 4 |
| 2-thread conversion | — | Built-in |
| Differential feed ratio (minimum) | — | 0.5 |
| Differential feed ratio (maximum) | — | 2 |
| Stitch length (minimum) | 1 mm | 1 mm |
| Stitch length (maximum) | 5 mm | 5 mm |
| Looper threading | — | Air (jet-air) |
| Needle threader | Manual | Built-in |
| Rolled hem conversion | — | Lever |
| Retractable upper knife | Yes | Yes |
| Adjustable cutting width | Yes | Yes |
| Tension system | Manual dials | Manual dials |
| Presser foot lift | — | 5.5 mm |
| Adjustable presser foot pressure | — | Yes |
| Maximum speed | 1300 spm | 1300 spm |
| Waste collector | — | Yes |
The differences that matter
- Built-in needle threader against manual → the Janome threads the needle with its own device
- Air-driven loopers and built-in 2-thread conversion on the Janome → fewer steps by hand at every thread change and no accessory to fit
- Same 1300 stitches per minute and 5 mm longest stitch → on speed the two are indistinguishable
Which one to choose
Choose Alfa Overlock 8703 if…
Choose the Alfa if you don't need the Janome's automation: with the same 1300 stitches per minute and stitch length up to 5 mm (manufacturer's stated values), the needle is threaded by hand. It has tension knobs, adjustable cutting width and a disengageable upper knife, as the Janome does.
Choose Janome AT 2000D if…
Choose the Janome if you thread often: built-in needle threader, air-driven loopers (a jet of air carries the thread along its path) and 2-thread conversion without an accessory. The presser foot lifts 5.5 mm and differential feed runs from 0.5 to 2. The trade-off: 7.9 kg.
Where to buy
Paid link: the price for you does not change.
As an Amazon Associate I earn from qualifying purchases.
The purchase links are the same as on the two product pages and don't influence the verdict. The product pages have the complete data.